The TV clicks and does not turn on

We are already so used to having televisions in the house that the failure of this device often drives us into a stupor. One of the options for the malfunction is the situation when it does not turn on at all, although some clicks are heard from it.

To understand this problem, you need to recall a little the principle of the device itself. The electrical signal enters the device through a cable that is connected to the antenna, receiver or equipment provider. With the help of several microcircuits, it is converted into the corresponding code and projected onto the screen in the form of an image, and an audio signal is transmitted to the speakers. The viewer at the same time enjoys watching a movie or show.

But all this is possible only on condition that the TV is connected to the power supply and is in good condition. When it doesn’t go further than a click when turning on, the problem is probably in the power supply. There are several options for the causes of the failure:

1. The result of the protection system. All modern models are equipped with a node that blocks the inclusion of the TV, if it has a serious malfunction. In this case, the relay is activated (therefore, there is a click), a system check is started, a problem is detected and the program terminates and turns off the power. From the outside, it just looks like the described situation.
2. For a long time the device was not used. This problem is especially typical of a number of older models of LCD TVs. Here, in addition to clicks, there may be other extraneous sounds. The screen may sometimes work, but the image often has defects.
3. The problem is the power node. In intensive use, over time, the components wear in this part of the device. At first, after a series of clicks, the screen will light up, but soon the TV may fail completely.

These are the most common causes, but there are many more, although they are less common.

IMPORTANT! Never try to diagnose the device yourself! This can not only lead to its permanent damage, but also exposes you to the risk of electric shock.

Do not try to fix the problem yourself. In any case, you must contact a specialized service center or a trusted master.

IMPORTANT! Do not attempt to solder or replace power supplies yourself. So you can significantly aggravate the problem and even bring the TV into complete disrepair!

The whole procedure can be represented in the form of an algorithm:

1. Turn off the TV and pack it in the box with documents and a power cable. Try to pave the voids with foam or foam.
2. Take the TV to the service and transfer it to the master under the inventory. In this case, you fill out the application and leave contact information for communication.
3. Wait for the call, agree on the repair procedure and the cost of work, as well as the deadlines.

Diagnostics will take quite a bit of time, like most repair cases, and in the near future it will be possible to enjoy your favorite show again.